tda100 panasonic User Manual

tda100 panasonic User Manual

F.C.C. REQUIREMENTS AND RELEVANT


INFORMATION

1. Notification to the Telephone Company

This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On

the side of this equipment is a label that contains, among other information, a product identifier in the

format US: ACJMF03AKX-TDA100. If requested, this number must be provided to the telephone

company.

Installation must be performed by a qualified professional installer. If required, provide the telephone

company with the following technical information:

• Telephone numbers to which the system will be connected

• Make: Panasonic

• Model: KX-TDA100 and KX-TDA200

• Certification No.: found on the side of the unit

• Ringer Equivalence No.: 0.3A

• Facility Interface Code: 02LS2, 04DU9.BN/DN/1KN/1SN, METALLIC

• Service Order Code: 9.0F, 6.0P

• Required Network Interface Jack: RJ21X, RJ48C, RJ2HX

2. Ringer Equivalence Number (REN)

The REN is used to determine the number of devices that may be connected to a telephone line.

Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming

call. In most, but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the

number of devices that may be connected to a line, as determined by the total RENs, contact the local

telephone company. The REN for this product is part of the product identifier that has the format US:

ACJMF03AKX-TDA100. The digits represented by 03 are the REN without a decimal point (e.g., 03 is

a REN of 0.3). For earlier products, the REN is separately shown on the label.

3. Incidence of Harm to the Telephone Lines

If this equipment causes harm to the telephone network, the telephone company will notify you in

advance that temporary discontinuance of service may be required. But if advance notice isn't practical,

the telephone company will notify the customer as soon as possible. Also, you will be advised of your

right to file a complaint with the FCC if you believe it is necessary.

4. Changes in Telephone Company Communications Facilities, Equipment, Operations and

Procedures

The telephone company may make changes in its facilities, equipment, operations or procedures that

could affect the operation of the equipment. If this happens the telephone company will provide

advance notice in order for you to make necessary modifications to maintain uninterrupted service.

5. Trouble with this equipment

If trouble is experienced with this equipment, for repair or warranty information, please see the attached

warranty, which includes the Servicenter Directory. If the equipment is causing harm to the telephone

network, the telephone company may request that you disconnect the equipment until the problem is

resolved.

6. Connection to Party Line

Connection to party line service is subject to state tariffs. Contact the state public utility commission,

public service commission or corporation commission for information.
 
 
downloadKX-TDA100 panasonic User Manual

0 comments:

Post a Comment

 
© 2009 ELECTRO,CIRCUIT, SCHEMA & DATASHEET | Powered by Blogger | Built on the Blogger Template Valid X/HTML (Just Home Page) | Design: Choen | PageNav: Abu Farhan