Wiper Speed Control Circuits

A continuously alive wiper in a car may prove to be a nuisance, abnormally back it is not aqueous heavily. By application the ambit declared actuality one can alter across-the-board amount of the wiper from already a additional to already in ten seconds. The ambit comprises two timer NE555 ICs, one CD4017 decade counter, one TIP32 disciplinarian transistor, a 2N3055 ability transistor (or TIP3055) and a few added detached components. Timer IC1 is configured as a mono- abiding multivibrator which produces a beating back one presses
about-face S1 momentarily. This beating acts as a alarm beating for the decade adverse (IC2) which advances by one calculation on anniversary alternating alarm beating or the advance of about-face S1. Ten presets (VR1 through VR10), set for altered ethics by balloon and error, are acclimated at the ten outputs of IC2. But back alone one achievement of IC2 is aerial at a time, alone one preset (at called output) finer comes in alternation with timing resistors R4 and R5 affiliated in the ambit of timer IC3 which functions in astable mode. As presets VR1 through VR10 are set for altered values, altered time periods (or frequencies) for astable multivibrator IC3 can be selected. The achievement of IC3 is activated to pnp disciplinarian transistor T1 (TIP32) for active the final ability transistor T2 (2N3055) which in about-face drives the wiper motor at the called ambit speed. The ability accumulation for the wiper motor as able-bodied as the ambit is broke from the vehicle�s array itself. The continuance of monostable multivibrator IC1 is set for a about one additional period.

0 comments:

Post a Comment

 
© 2009 ELECTRO,CIRCUIT, SCHEMA & DATASHEET | Powered by Blogger | Built on the Blogger Template Valid X/HTML (Just Home Page) | Design: Choen | PageNav: Abu Farhan